Oven Repair in Utah

Won't heat, bakes unevenly, slow to preheat, locked after self-clean, or showing an F code? We meter it first, then fix it.

What does oven repair involve?

Oven repairs run $150 to $1,000, depending on the fault, the part and the model. The diagnostic visit is $99 to $159, and it's credited toward the repair if you go ahead. Christian or Tim diagnoses first, then you decide. Every repair carries a 90-day guarantee on parts and labor.

An electric oven heats with a bake element at the bottom and a broil element at the top, and often a convection element and fan at the back. A temperature sensor tells the control how hot it is, and relays on the control board switch the elements on and off to hold the set temperature. A thermal fuse cuts power if the oven overheats, and a door lock motor holds the door shut during self-clean. When an oven misbehaves, the fault is almost always one of those parts, the door seal, or the 240V supply.

The technician meters the supply, the elements, the fuse and the sensor, reads any codes, and gives you the fault and the price before any repair.

Last updated

Stopped after self-clean? Self-clean runs the oven far hotter than normal cooking. That extreme heat is when tired parts fail: the thermal fuse, the lock motor, an element or the board. Tell us if that's when it stopped.

Stovetop issue instead? Burners and glass tops are covered on Stove & Cooktop Repair.

Common oven problems

No heat, clock works
The bake element, the thermal fuse, a control relay, or one tripped leg of the 240V breaker. The clock runs on lower voltage, so a working display doesn't mean the oven is getting full power.
Broil works, bake doesn't
The bake element or its relay. Look at the bake element for a visible break, blister or burned spot.
Runs hot or cold, or bakes unevenly
A drifted temperature sensor, a flat door gasket, a sagging door hinge, or a seized convection fan.
Slow to preheat
A weak element, or a door that isn't sealing and lets heat escape.
Locked after self-clean
The door lock motor or its switch.
F code on the display
A fault in the sensor, door lock, keypad or control board circuit. The code tells us which circuit to test first.
Samsung front-load washer with the top panel off for diagnosis, OremFrigidaire stacked washer-dryer serviced in ProvoSamsung front-load washer with the door open after a water leak call, Vineyard

How it works

  1. Call or book online

    Give us the brand, the model number (inside the door frame or behind the drawer), the symptom and any F code.

  2. Quick checks

    Check the double breaker, look for breaks on the bake element, check the door for gaps, and time how long it takes to preheat to 350°F. Don't run self-clean.

  3. Diagnosis

    The supply voltage, elements, fuse and sensor are metered. Codes are read. The door lock, fan and seal are checked.

  4. You decide

    Repair or not, your call.

  5. Repair

    The part is replaced, the oven is run to temperature and checked with a thermometer, and the repair carries a 90-day guarantee.

Brands we repair

Wolf, Viking, Thermador, Gaggenau, Dacor, Fisher & Paykel, KitchenAid, GE, Whirlpool, Frigidaire, Bosch, Samsung, LG, Maytag, Electrolux, Kenmore, Jenn-Air, Amana and Hotpoint. For built-in luxury ovens, see High-End Appliance Repair.

FAQ

How much does oven repair cost?

Repairs run $150 to $1,000, depending on the fault, the part and the model. A bake element is at the low end, a control board at the high end. Wall ovens that have to come out of the cabinet take more labor. The $99 to $159 diagnostic is credited toward the repair if you go ahead.

Why won't my oven heat?

Check the bake element first, then the thermal fuse, the control relay and the breaker. If the clock works but nothing heats, one leg of the 240V supply may be lost.

Why does my oven bake unevenly?

A drifted temperature sensor, a worn door gasket, a sagging hinge, or a convection fan that has stopped. An oven thermometer in the center of the cavity will show whether it's running hot or cold.

Do you repair Wolf and Thermador ovens?

Yes, including dual-convection wall ovens.

Why is my oven so slow to preheat?

A weak element, or a door that doesn't seal and lets heat out.

My oven door is locked after self-clean. What do I do?

Let the oven cool completely first. Many doors release once the oven is back to room temperature. If it stays locked, it's usually the lock motor or its switch. Don't force it, because that can break the latch.

Is it guaranteed? Where do you work?

Every repair carries a 90-day guarantee on parts and labor. We work across Utah County and Salt Lake County.

Tell us what is going on. We'll get back to you.

Every repair carries a 90-day guarantee on the parts we install and on our labor.

  • Rated 4.8 on Google from 290 reviews
  • Monday to Friday, 8am to 5pm
  • Diagnosed first by technicians with more than 10 years each
Prefer to talk? Call(385) 238-1594

Book oven repair

Your details, step 1 of 3

* Required

Format: (XXX) XXX-XXXX

What needs fixing?
When suits you?

Request received.

We've got your details and we'll get back to you. Need us sooner? Call (385) 238-1594.

Rather talk now? (385) 238-1594