What does front-load washer repair involve?
Front-load washer repairs run $150 to $1,000, depending on the fault, the part and the model. The diagnostic visit is $99 to $159, and it's credited toward the repair if you go ahead. Christian or Tim diagnoses first, then you decide. Every repair carries a 90-day guarantee on parts and labor.
Front-loaders use less water and spin faster than top-loaders, and that design creates its own faults. The rubber door boot seal holds the water in, and its folds trap residue that turns into mold and smell. The door lock has to engage before the drum can fill or spin. The drum hangs on shock absorbers and springs and turns on bearings at the back of the tub. And a pump filter, usually behind a small panel at the bottom front, catches coins and debris before they reach the drain pump.
We take the panels off, test the parts that match your symptom, and give you the fault and price before any repair.
Last updated
Fighting the smell: wipe the boot dry after each wash, leave the door ajar, and run an empty hot wash regularly. If a black film won't wipe off the boot, the boot needs replacing.
Don't force a locked door. It breaks both the latch and the lock, which turns one repair into two.
Top-loaders and stacked units are covered on Washer Repair.
Recent front-load jobs
- Samsung WF328AAW, Orem: top panel off to diagnose the control board, wiring harness, water inlet valves and drum.
- Samsung VRT, Vineyard: water pooling at the base. The door boot seal or drum was suspected.
Common front-load problems
- Leak at the front
- A torn or dirty door boot seal. Debris caught in the boot can hold it open just enough to let water out.
- Leak underneath
- The drain pump, the hoses or the tub.
- Musty smell
- Residue and mold in the boot fold, or a clogged pump filter holding stagnant water.
- Won't spin
- The door lock, worn shock absorbers, an unbalanced load, or the motor or its speed sensor.
- Rumble that grows with speed
- Worn drum bearings. Often the tub seal has let water reach the bearings over time.
- Door won't unlock
- A failed lock assembly, or water still in the drum. The door stays locked until the drum drains.
- Rattle on drain
- Something caught in the pump filter.
- Thump on spin
- Worn shock absorbers.



How it works
Call or book online
Give us the brand, the model number (inside the door frame), the symptom, any code, and when in the cycle it happens.
Before we arrive
Shut off the taps if it's leaking, leave a locked door alone, check the boot for tears, and note any code.
Diagnosis
Panels off. The lock, pump, shocks and motor are metered. The boot is inspected. The bearings are checked. Codes are read.
You decide
Repair or not, your call.
Repair
The part is replaced, and the repair carries a 90-day guarantee.
Brands we repair
Samsung, LG, Whirlpool, Maytag, GE, Bosch, Electrolux, Frigidaire, Kenmore, Speed Queen, Asko, Fisher & Paykel, Blomberg and Haier.
FAQ
How much does front-load washer repair cost?
Repairs run $150 to $1,000, depending on the fault, the part and the model. Bearing jobs are at the high end because the tub often has to come apart. Door locks, pumps and boots are usually lower. The $99 to $159 diagnostic is credited toward the repair if you go ahead.
How do I get rid of the smell in my front-loader?
Wipe the boot dry, leave the door ajar between washes, and run hot empty washes. Clean the pump filter too. If the black film on the boot won't clear, the boot needs replacing.
Can the door gasket be replaced?
Yes. A torn or moldy door boot seal is a common front-load repair.
My front-loader isn't spinning or draining. What's wrong?
For spin problems, the door lock, worn shocks or an unbalanced load. For drain problems, the pump or the pump filter. A washer that can't drain won't spin either, so the drain is always checked first.
Do you repair Samsung front-loaders?
Yes. Two of our recent jobs were Samsung front-loaders in Orem and Vineyard.
What does my error code mean?
Tell Samuel the code when you book. It points to the circuit the machine thinks has failed, which helps the technician start in the right place.
Is it guaranteed? Where do you work?
Every repair carries a 90-day guarantee on parts and labor. We work across Utah County and Salt Lake County.